Fsbuild-2 Flight Planner

I have tried just dropping the retrofit A320 panel.cfg into the PA319 and PA321 but for some reason it doesn't work. Not sure why because the panel.cfg looks similar if not identical. I thought maybe because I have the Francois Dior enhanced Project Airbus 319/320/321, but that isn't it because the A320 worked perfectly. Anyone have ideas on this or figured out a panel.cfg? Thanks in advance!

Ended up figuring out how to fix it myself. The reason the ISG retrofit for the PA320 panel.cfg didn't work in the 319 or 321 was because those two models had an extra ECAMS window. Both links below are for the PA319 CFM and IAE, and the PA321 CFM and IAE. Reminder this is for the Special Version Francois Diore Project Airbus series found on AVSIM or Flightsim.

321
https://drive.google.com/folderview?id= ... sp=sharing

319
https://drive.google.com/folderview?id= ... sp=sharing

Ernie- feel free to post to the Retrofit page.

When I reach the TD point (top of descent) and don't intervene manually, the aircraft does initiate a descent but the autopilot sets the altitude at 300 feet. If I set the MCP altitude at 2000 feet, for example, in advance of the TD point (as is the case in some addons), then the aircraft does initiate a descent, but at the next waypoint, the autopilot altitude is again set to 300 feet. It would appear that the VNAV is not following the prescribed altitudes in the flight plan during the descent.