Fsbuild-2 Flight Planner

I am trying to create a route using consecutive bearing/distance entries on the Legs page. My example is KSEA to 165 @ 5 nm to 180 @ 100 nm, etc. My first entry in Legs is KSEA165/005. KSEA01 (showing 165 5 NM) is posted on line 1. Good so far. Then I try to enter KSEA01180/100 and I get a NOT IN DATABASE error. What am I doing wrong? Another curious thing - when I execute after the first entry, the bearing and distance is increased by 1. It shows 166 6 NM.

The second leg is incorrect; it should be KSEA180/100 or KSEA011/100. Bearings need to be in whole degrees.

Thanks. I don't get the database error message. But I was hoping it'll work differently than the way it does using this method. I wanted the second leg to end at the specified bearing and distance from the first created waypoint which is KSE01. Using the method you prescribed the second leg ends at the specified bearing/dist from the origin (KSEA). As an example, I want to go due south 10 nm from KSEA, then turn 90 to go due west for 10 nm. I would enter KSEA180/010 the KSEA270/010. I would wind up due west 10 nm from KSEA. The heading/dist for the second leg would be 315/14. Not what I wanted. Well if that's the way it has to be then, it'll require manual calculations on my part. There are there FMC's that work the way I described. I guess that's a limitation of the this FMC. Thanks for your input.