Fsbuild-2 Flight Planner

_________________
Howard

System: Intel Core 2 Duo E6700, Intel 975XBX mobo, 4GB DDR2 memory, nVidia GeForce 7950GX2 with 1GB memory, 500GB hd, 3 19" monitors with the Matrox TripleHead2Go. Also, the Saitek Yoke & Throttle Quadrants and the CH Pedals.

hi Howie,

I have the same problem but cannot find the post on this forum that got you going, please tell me where it is.

Go well,

_________________
Fly nicely........land better.

hi Howie,

I have the same problem but cannot find the post on this forum that got you going, please tell me where it is.

Go well,

_________________
Fly nicely........land better.

To manually update the .ocx file, do this:

Click Start/run and type cmd then hit enter. This will open up a DOS commandline box.

Type EXACTLY regsvr32 \windows\system32\msflxgrd.ocx and hit Enter. You should see a pop up saying that it was registered. IMPORTANT NOTE: You must put a space after regsvr32, then type in the \windows\system32..........

Hi Flowdrip,

Thanks for the info, I just could not find the page or any other thread where Howie had found the answer from.

I eventually got my template installer to work by purchasing and loading FsBuild, after that it all worked fine, but I am still not sure if this was a pre-requisite or not (?), I did check the rest of the forum for any hint of this, but also could find nothing about it.

Thanks and go well.

Steve Frampton

_________________
Fly nicely........land better.

_________________
Fly nicely........land better.