My usual routine...
Load up FS2004 with ASv6, see what the active runways are, then use FSBuild to create flightplan. Once created I use whatever aircraft FMC to load up the created flightplan, and away I go.
I retrofitted a DC8-70 with the ISG FMS (the non-Boeing looking one, whatever that one is called), and went to grab the flightplan - but it wasn't there. The only way I could get it to show up was by reloading the aircraft. This is a pain because I have to reset everything.
So my question is; is there a way to have the FMS scan the flighplan folder every time the page is accessed? If not, might this be implemented in the future? Thanks...
- daniel
|