Fsbuild-2 Flight Planner

I have FSBuild 2.0 and Win7 64bit, and FS2004. FSB does not work properly, cannot export plans, and the print out of the flight plan is compressed.

What version of FSBuild is compatible with Win7 64 bit, and FS2004?

I have FSBuild folder in my D drive, outside of the FS2004 folder, which is also in the D drive. The operating system is in my C drive.

Would appreciate your advice.

Thanks.
Stanner

Ernie,
Thank you for replying. I do get an error message. When trying to export a flight plan EGLL to EDDF,for my PMDG B737, I got the error message
"Errror-unable to create PMDG 737NG FMC file\PMDG\Flight Plans\.

I am using Win7 64bit, a new computer, so I installed FSB2 from a backup disc I purchased with the download
from Sim Market.
I installed FS2004 and FSX in a separate drive (D), from the operating system (C). It is in a Folder I labled
D:\FSGames\Flight Simulator 9, and D:\FSGames\FSX. I installed FSBuild in a separate folder outside of FSGames. D:\FSBuild.
Should FSBuild be installed someplace else? What is the recommended installation path?

I have used your program for years.

Thanks for any help you can provide me

Stanner

Ernie,

Thank you. I have not installed FSBuild in years, and I forgot to set up the FS_HOME. I prepared a flight plan, and it was exported correctly.

However, I was able to set the location path (column 4) for FS9 only. How does one set the export directory (column 4) for both FS9 and FSX?

I could only do FS9 or FSX, not both.

Thanks again.

Stanner

Ernie,

It seems I must change the export settings in Options back and forth between FS9 to FSX is this correct?


Stanner

Ernie,
Thank you for the prompt reply.

When I copy the entire FSBuild folder, I would need to name it something other than FSBuild, would FSBuild2 work?
I could then rename the FSB.exe short cuts FSB1 and FSB2. Do you agree?

Again thanks for your help.

Stanner

Ernie,

I have FS Build working properly for both FSX and FS9. Thanks to your help in the past. I have the FSBuild version 2. I am using
Win 7 64 bit.
However, I have never been able to get a good proper print out of the flight plan. I get a COMPRESSED PRINT out of the
flight plan when I print the ROUTE WAYPOINT TABLE only. Prints of all other are ok. I have lived with this problem by using another computer which has win xp.

Is it possible to correct this problem?

Thanks.
Stanner

PS Is it worth updating to a later version fo FS Build? Is thiere a cost?