Fsbuild-2 Flight Planner

if I save a flight while flying and later restore it the airplane comes back but no route. after several try's I got a message " destination airport called for in the rte file not found"
Any thoughts? I use fsbuild for all my flight plans.
Any help is appreciated.
Don Emerson

You're going to have to give more information - what simulator and what aircraft would be a good start.

DJ

Since I presume that you have programmed the FMC, and saved the route via the built-in save function, FSBuild really has nothing to do with the problem if you used it to load the route to begin with and it loaded correctly. I don't know what to tell you except to check over on the PMDG support forum at AVSIM and see if someone has a clue.

DJ

PMDG said the problem was with the FSBUILD file having two tabs not one as expected on the saved flight file see attached files SALMON.RTE
Don Emerson

I don't see the attachment at all... If indeed two tabs are an issue you can get around it simply by loading the .rte file as your coroute and then saving it via the aircraft's own function. That should take care of any problem.

DJ

I have found a work around. If I copy a flight route from flightaware then go to fsbuild put the dep and des in and paste the copied route into fsbuild route run build. Everything works. Not the best solution but it works. Thanks for all your suggestions.
Don Emerson