Fsbuild-2 Flight Planner

Hi,

Only had the program for a week and found a few things you might be able to clarify for me and a couple of slight amendments.

Currently you have 4 rwys shown at EGCC (Manchester) however you can remove the 06L/24R and 06R/24L entries as they are redundant following a renumbering to 05/23 etc.

I put in a plan EGKK to EGCC and self generated a plan however I noticed it didn't work of any SID but choose to route
EGKK CFD LESTA.DAYN1B EGCC
but the correct routing with a SID should have been
EGKK LAM4M UL10 BPK UN601 LESTA DAYN1B EGCC
little confused why it choose the route it did ignoring any SID's.

Tried a reverse route and SID/STAR's etc all OK but noticed that wpt HON58 was miles out of position until I took a look at the intersections file to find they are two HON58's listed. Both are in fact correct as the other is a point for a SID from EGGD (Bristol). How do I get the program to select the right HON58? Also noticed quite a few duplicate waypoint names so quite likely this happens on other plans.

Finally noticed a few times that the flightplan line will correctly show a SID/STAR but the waypoint listing will only show the last point and DCT to/from that point. For example
EGLL DVR SID L9 KONAN UL607 SPI UT180 ROLOR T180 EPIN5W EDDF
was OK but from the last awy's point it just listed
REMBA 012 UL607 109 456 456 00/01 00/49 .../... 0126/... 0148/...
SPI 113.10 029 UL607 107 455 455 00/03 00/53 .../... 0130/... 0143/...
EDDF 117 DCT 101 332 332 00/21 01/14 .../... 0158/... 0115/...

Cheers Ron

Thanks Ernie,

Didn't mean to ignore the update, just been a bit busy recently.

Thanks Ron